Filter
Top Products
9-31
Assembly of USB / Antenna PCB
SHEET Attach.
1. Insert and remove plug straight
2. Don't make covering damaged at the time of cable handling.
㸈
Connect Cable into the CN2
of EXT ANT PCB and process
the wire.
㸇䇭
Attach SHEET to Cable
㸉
Attach EXT ANT PCB to the Cabinet
and fix with Screw.
EXT ANT PCB Set
SCREW-1
Tighten
SCREW-2
Tighten
Cable
ANT CABLE SHEET Attach.
CAUTION
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
(Notes)
FPC Edge Standard
1r1
ANT CABLE PLATE Set
SCREW Tighten
WHIP ANT CABLE
Insert the Cable plug.
CABLE (DFJS1055ZA)
Ensure the Flex tag
does not run over.
Fit to the groove.
Misalignment: 1 or less
Pass the Cable along the
intermediate chassis
concave and connect it to
the coaxial Connector.
Match to the edge.
Misalignment: 2 or less
SHEET Attach.
S2
54~56
S1
Torque of tightening screw :0.2 ± 0.02N·m(Ṑ2.0 ± 0.2kgf·cm)
Reusing the attaching parts is impossible
<Notes>
1Apply the load when attaching the attaching parts. 20䱊30䰚䯴2䱊3Kgf䯵/cm2
CAUTION
S1:Insulation S2:Bitten S3:Sharp Edge
S4:Part No. Check S5:Other
Tighten
Screw
Connect
Connect
USB SUB PCB
USB Cable
㪪㫌㪹㫊㫋㫉㪸㫋㪼㩷㪼㫅㪻㩷㪽㪸㪺㪼㩷㪸㪻㪻㫀㫋㫀㫆㫅㪅
㪛㫀㪽㪽㪼㫉㪼㫅㪺㪼㩷㫃㪼㫊㫊㩷㫋㪿㪸㫅㩷㪈
㪚㪥㩷㪼㫅㪻㩷㪽㪸㪺㪼㩷㪸㪻㪻㫀㫋㫀㫆㫅㪅
㪛㫀㪽㪽㪼㫉㪼㫅㪺㪼㩷㫃㪼㫊㫊㩷㫋㪿㪸㫅㩷㪈
㪧㫆㫃㫐㫄㫀㪻㪼㩷㫋㪸㫇㪼㩷Paste
㪠㫅㫊㫌㫃㪸㫋㫀㫆㫅㩷㫎㫀㫋㪿㩷㪸㩷
㪾㪸㫊㫂㪼㫋㩷㩿㪺㪸㪹㫀㫅㪼㫋㪀
CD Edge Sheet