Filter
Top Products
9. Programmable Features
71
Approving users for the LAN
connection
{#}{5}{3}{2}
{0} “Disabled” (default): Deactivates this feature.
{1} “Enabled”: The unit will deny/approve access from the pre-programmed
IP patterns. Whether to deny or approve, and up to 4 patterns can be
programmed through the web browser interface.
1. Start Multi-Function Station.
2. [Utilities] i [Configuration Web Page] i [Network Configuration]
3. Type “root” as the user name, then enter the password (feature #155 on
page 57). i [OK]
4. Select the [LAN Feature] tab.
5. Click [Edit] next to [Approved Users].
6. Click [Edit] next to [Filter].
7. Change the mode and edit IP filtering information. i [Submit]
8. Close the web browser.
Setting the IP address
automatically for the LAN
connection
{#}{5}{3}{3}
This feature will be displayed only when feature #500 is activated.
{0} “Disabled” (default): Deactivates this feature.
{1} “Enabled”: IP address will be allocated automatically without using a
DHCP (Dynamic Host Configuration Protocol) server.
Setting HTTPD for the LAN
connection
{#}{5}{3}{4}
{0} “Disabled”: Denies access to the web browser.
{1} “Enabled” (default): Allows access to the web browser.
IPv6 protocol
{#}{5}{3}{5}
{0} “Disabled” (default): Deactivates this feature.
{1} “Enabled”: IPv6 protocol can be used. After installing the printer driver, be
sure to change the port to IPv6 protocol. You can check the IPv6 protocol
address by printing the “Setup List” (page 104).
Note:
L To activate this feature, you need to turn the power switch of the unit OFF,
then ON.
Setting the paper input tray to
use for the scan to e-mail
print feature
{#}{5}{6}{5}
This feature will be displayed only when the optional input tray is installed.
{1} “#1” (default): Standard input tray
{2} “#2”: Optional input tray
{3} “#1+#2”
Note:
L If you select “#1+#2”, make sure the same paper size is selected for the
following:
– Standard input tray (feature #380 on page 58)
– Optional input tray (feature #382 on page 58)
If either is changed, “#1” will be selected automatically.
Feature/Code Selection