Filter
Top Products
Automatic dialing mode setting
When the power cord is connected, the unit will start detecting the dialing mode.
Display:
Wait until one of the following messages is displayed:
—If your line has touch tone service, the unit will display the following message:
Display:
—If your line has rotary pulse dial service, the unit will display the following message:
Display:
¡If you connect the power cord before connecting the telephone line cord, the following messages will be
shown alternately:
Connect the telephone line cord.
¡If the power cord is disconnected or a power failure occurs, the unit will detect the dialing mode again when
power is restored.
¡You can change the dialing mode setting manually. See page 58.
TEL LINE IS OPENCONNECT TEL LINE
LINE IS PULSE
LINE IS TONE
CHECKING LINE
10
Quick Start
For Assistance, Call 1-800-435-7329
Installation
Connecting the telephone line and the power
outlet
Note:
¡For additional equipment protection, we recommend the use of a surge protector. The following types are
available: TELESPIKE BLOK MODEL TSB (TRIPPE MFG. CO.), SPIKE BLOK MODEL SK6-0 (TRIPPE
MFG. CO.), SUPER MAX (PANAMAX) or MP1 (ITW LINX).
¡When you operate this product, the power outlet should be near the product and easily accessible.
¡If the following message is displayed when the unit is plugged in, the recording paper set lever is released.
Display:
Move the lever back (see step 5 on page 9).
CHECK LEVER
Power outlet
(120 V, 60 Hz)
Line surge
protector
( )
( )
Power surge
protector
Power socket
Single telephone line
(RJ11C)
Power cord
Telephone line cord
Handset
Handset cord
1. Connect the handset and handset cord.
2. Connect the telephone line cord.
3. Connect the power cord.
¡When the power is turned on for the first
time, the unit will print an information list
about the starter film.