Filter
Top Products
67
Special Settings
1 2 3
4 5 6
7 8 9
0
Signaling your pager that you have received a fax
document
This feature allows your unit to call your pager when your unit receives a fax message.
1
Press (MENU).
Display:
2
Press K, then G @.
3
Press (START/COPY/SET).
4
Press or to select “ON”.
¡If this feature is not required, select “OFF”.
5
Press (START/COPY/SET).
6
Enter your pager number.
¡If this feature does not work properly, press
(REDIAL/PAUSE) more than once at the end of
your pager number to extend the paging time.
If you wish to display a message on your pager,
enter the message after your pager number and
(REDIAL/PAUSE).
Programming methods may vary depending on
the pager company. Contact your pager company
for details.
¡You can enter a total of 46 digits and/or pauses.
7
Press (START/COPY/SET).
8
Press (MENU).
Note:
¡This feature is not available when the receive mode is
set to the TEL mode.
NO.=
MODE=ON [Ÿÿ]
MODE=OFF [Ÿÿ]
FAX PAGER
SYSTEM SET UP
(MENU)
Dial keypad
(START/COPY/SET)
(REDIAL/PAUSE)