Filter
Top Products
Switching the projector on/off
28 -
ENGLISH
Basic Operation
Switching the projector on/off
Power cord
Use the power cord included to prevent removal of the power cord and make sure it is fully inserted into
the projector.
Make sure the <MAIN POWER> switch is on the <OFF> side before connecting the power cord.
Use the power cord included and ensure that it is fully inserted.
For power cord handling details, see “Read this rst!”. (
pages
6
to
13)
Connecting
■
Fully insert until the tabs on the left
and right make a click sound.
Disconnecting
■
Pull out while pushing on the tabs on
the sides.
Power indicator
The power indicator indicates the power status.
Check the status of the power indicator <ON (G) / STANDBY (R)>
before operating the projector.
Indicator status Status
No illumination or ashing Main power is switched off.
Red
Lit
Power is switched off. (Standby mode.)
Press the power <
/ | > button to start projection.
* Does not operate when the lamp indicator or temperature indicator is ashing.
Flashing
Power is switched off (standby mode) and the [POWER ON LINK] is set to
[YES] in the VIERA Link settings.
For details about [POWER ON LINK], see [POWER ON LINK] (
page
78).
Green
Flashing
The projector is preparing to project.
Projection starts after a brief pause.
Lit Projecting.
Orange
Lit
Preparing to switch off the power.
The power is switched off after a while. (Changes to the standby mode.)
Flashing
The power <
/ | > button is switched on again in the power off preparation
mode.
Preparing to project. Projection starts after a brief pause.
Power indicator