Filter
Top Products
[3D SETTINGS] menu
62 -
ENGLISH
Settings
Note
If a setting other than [AUTO] is selected when the input is switched to HDMI, [3D INPUT FORMAT] is changed to [AUTO]
z
when actions such as turning the power of/on, switching input, or switching the signal are performed on the connected
device.
See the following table regarding settings, input signals and the image for viewing.
Switching 3D
format
Input signal
[AUTO] [SIDE BY SIDE]
[TOP AND
BOTTOM]
[NATIVE]
FRAME
PACKING
(Normal 3D video)
SIDE BY
SIDE
(Normal 3D video
*1
) (Normal 3D video)
TOP AND
BOTTOM
(Normal 3D video
*1
) (Normal 3D video)
2D
*1 Depending on the signal, it is necessary to set [3D INPUT FORMAT]. (
page
61)
During 2D to 3D conversion, [3D INPUT FORMAT] cannot be performed.
z
Depending on the device connected, there are cases where it differs from the content described above.
z
A FRAME PACKING signal is a 3D signal for when a Blu-ray 3D compatible disc is played back with a device such as a 3D
z
compatible Blu-ray player connected using HDMI.
The SIDE BY SIDE signal uses two videos arranged next to each other and converts them to a 3D video.
z
A TOP AND BOTTOM signal is when two videos are arranged on top of each other are used and converted to a 3D video.
z
When the freeze function is being used, the [3D INPUT FORMAT] cannot be executed.
z
As regards the “Normal 3D video” shown in the table, a 3D video is available when power is supplied to the 3D Eyewear.
z
The 3D effect is not achieved if the power supply is cut off.