Filter
Top Products
[Setting] menu
76 - ENGLISH
Settings
[HDMI setup]
If the image cannot be correctly displayed when an
external device is connected to the projector using
HDMI, change the settings.
1) Press
▲▼
to select [HDMI setup].
2) Press the <ENTER> button.
3) Press
▲▼
to switch the setting.
[Normal] [Enhanced]
[Normal]
Select when the output from the
external device is “NORMAL
*1
”.
[Enhanced]
Select when the output from the
external device is “ENHANCED
*1
”.
*1: The titles of the output settings differ depending on the
device. For details, refer to the operating instructions of the
external device.
[Logo]
Sets logo selection and the PIN code for logo
selection.
1) Press
▲▼
to select [Logo].
2) Press the <ENTER> button.
■
z
The sub menu 2 is displayed.
3) Press
▲▼
to select.
■■
[Logo select]
1) Select [Logo select], and press the
<ENTER> button.
2) Press
▲▼
to switch the setting.
■
z
The setting will change as follows each time
you press the button.
[Off] [User]
*1
[Default]
[Off] Clears logo from screen.
[User]
*1
Displays the image registered by the
user.
[Default]
Displays in the factory default
settings.
*1: Available when the image is registered.
■
z
“Logo Transfer Software” is required to register
the image.
■■
[Logo PIN code lock]
Sets the system to make the setting and changing
of the “logo” only by the administrator.
1) Select [Logo PIN code lock], and press
the <ENTER> button.
■
z
The PIN code input screen is displayed.
2) Press
▲▼◀▶
or the number (<0> -
<9>) buttons to enter the PIN code.
3) Press
▲▼◀▶
to select [Set].
4) Press the <ENTER> button.
■
z
If the PIN code is accepted, the projector
returns to the sub menu 2.
5) Press
▲▼
to switch the setting.
[Off] [On]
[Off]
The logo selection can be changed
without the PIN code.
[On]
The PIN code is required to change
the logo selection.
Note
■
z
The entered PIN code is displayed with * mark on
the screen.
■
z
The factory default setting for the logo PIN code is
“4321”.
■
z
To re-enter a number, press
◀▶
to select the digit
to re-enter, then press
▲▼
or the number (<0> -
<9>) buttons to re-select the number.
■
z
Move the cursor to [Cancel] and press the
<ENTER> button to return to the sub menu 2.
■
z
If [Logo PIN code] and the number are displayed in
red, an error has occurred. Re-enter the number.