Filter
Top Products
[Setting] menu
78 - ENGLISH
Settings
[Power management]
1) Press
▲▼
to select [Power
management].
2) Press the <ENTER> button.
■
z
The sub menu 2 is displayed.
3) Press
▲▼
to select an item, and press
the <ENTER> button.
[Off]
Cancels power management
function.
[Ready]
Turns off the lamps and starts cooling
when the time set using [Timer] has
elapsed. While lamp is being cooled,
the standby indicator <STANDBY>,
and the power indicator <POWER>
are ashing, you cannot operate the
projector.
When lamp cooling has nished, the
power indicator <POWER> continues
ashing and the standby indicator
<STANDBY> lights up instead of
ashing, indicating that the projector
is now in the power management
mode.
From this point, if a signal is input
or operations are performed on the
projector, the lamps will turn on and
the projection will start.
[Shut down]
Turns off the lamps and starts cooling
when the time set using [Timer] has
elapsed. During lamp cooling, you
cannot operate the projector.
When lamp cooling has nished, the
power will turn off.
[Timer] Sets times from 1 - 30 minutes.
Note
■
z
The factory default setting is [Off].
■
z
The power management function cannot be used
when the freeze function (
page 47) or shutter
function (
page 47) is in use.
■
z
When the power management function is started,
[P-timer] is reset.
[Direct on]
This is a function for automatically switching on
the power of the projector when the power cord is
connected, without requiring operations on the power
<POWER ON> button on the remote control or the
power button on the control panel.
1) Press
▲▼
to select [Direct on].
2) Press the <ENTER> button.
3) Press
▲▼
to switch the setting.
[Off] [On]
[Off]
Enables normal operations to turn
on/off the power.
[On]
Allows power to be turned on
directly.
Note
■
z
Be sure to turn on/off the power using the correct
operations.
■
z
Pressing the power <POWER ON> button on the
remote control or the power
button on the
projector will not turn on the power until the lamp
cooling has nished and the lamps are ready to be
turned on again.