Filter
Top Products
[Setting] menu
ENGLISH - 81
Settings
■■
[Effect]
Sets special effects when shutter is opened and
closed.
1) Select [Effect], and press the <ENTER>
button.
2) Press
▲▼
to switch the setting.
[Off] [L 1] [L 2]
[Off] Does not set special effects.
[L 1]
Sets fade in and fade out when the
shutter is opened and closed.
[L 2]
Sets slower fade in and fade out
than L1.
■■
[Release key]
Sets the release button when shutter is closed.
1) Select [Release key], and press the
<ENTER> button.
2) Press
▲▼
to switch the setting.
[Any] [SHUTTER]
[Any]
The shutter function is canceled by
pressing any button on the remote
control or projector body, and the
function of the pressed button is
executed.
[SHUTTER]
Only the <SHUTTER> button on the
remote control or the control panel
can be canceled.
Note
■
z
If the power is turned on again after the power is
turned off during the setting or the lamp is turned off
with the [Management] setting, the shutter function
is canceled.
■
z
The setting of the selected item is enabled.
■■
[Management]
Sets a time between closing of the shutter and the
lamps turning off.
1) Select [Management], and press the
<ENTER> button.
2) Press
▲▼
to select.
■
z
You can set times from 5 - 480 minutes.
Note
■
z
When the management function is active, the lamp
is turned off and the projector will begin a cooling
operation.
■
z
When cooling has nished, the power of the
projector body is turned off and the standby
indicator <STANDBY> turns on.
■
z
The shutter indicator <SHUTTER> begins ashing
in blue as the cooling operation begins.
■
z
The ashing continues after the cooling has
nished and the standby indicator <STANDBY> has
turned on.
■
z
The ashing stops when the projector power is
turned on again.
■
z
The power management function does not work
when the image is blocked by the [Shutter].
■
z
The factory default setting is “180 minutes”.
■
z
You can set the time while the function cannot be
set to off.