Filter
Top Products
[Setting] menu
ENGLISH - 83
Settings
■■
[Filter counter timer]
Sets a time to display a notication that the lter
has reached the end of its replacement cycle.
1) Select [Filter counter timer], and press
the <ENTER> button.
2) Press
▲▼
to switch the setting.
[Off] [1000 H]
[12000 H] [2000 H]
[8000 H] [3000 H]
[6000 H] [4000 H]
Note
■
z
When [Off] is selected, blockages are detected
automatically.
■
z
When the set time is exceeded,
is displayed.
■■
[Filter counter reset]
Resets the value of [Filter counter].
After replacing the lter, be sure to reset the
counter.
1) Select [Filter counter reset], and press
the <ENTER> button.
■
z
A screen for conrming whether to reset is
displayed.
2) Select [Yes], and press the <ENTER>
button.
■
z
The conrmation screen is displayed.
3) Select [Yes], and press the <ENTER>
button.
Note
■
z
Reset only after replacing the lter.
■
z
When reset, the display of [Filter warning]
disappears.
[P-timer]
1) Press
▲▼
to select [P-timer].
2) Press the <ENTER> button.
■
z
The sub menu 2 is displayed.
3) Press
▲▼
to select.
■■
[Count up]
Elapsed time is counted from 00 min 00 sec.
Elapsed time from 00 min 00 sec to 180 min 00
sec is displayed.
■■
[Count down]
Elapsed time is counted down from the set time.
Set the time using [Timer].
■■
[Timer]
Sets the [Count down] time.
1) Select [Timer], and press the <ENTER>
button.
2) Press
▲▼
to select.
Note
■
z
The factory default setting is “10 minutes”.
■
z
When [Count up] is selected, this item is grayed out
and cannot be selected.
■■
[Start]
Starts the count-up or countdown.
1) Select [Start], and press the <ENTER>
button.
■
z
The menu screen is cleared and the timer is
displayed.
■■
[Stop]
Pauses the count-up or countdown.
1) Select [Stop], and press the <ENTER>
button.
■
z
The stopped state of the timer is displayed for
approximately three seconds, then the display
returns to the menu screen.