Filter
Top Products
Specications
Model No. PT-VW345NZ PT-VX415NZ
Power supply
AC100 V - 240 V, 50 Hz/60 Hz
Power consumption
100 V - 240 V, 3.5 A-1.3 A, 300 W
When [STANDBY MODE] of [PROJECTOR SETUP] is set to [ECO]: 0.4 W
When [STANDBY MODE] of [PROJECTOR SETUP] is set to [NORMAL]: 14 W
LCD
panel
Panel size
1.5 cm (0.59")
(aspect ratio 16 : 10)
1.6 cm (0.63")
(aspect ratio 4 : 3)
Display method
3 transparent LCD panels (RGB)
Drive method
Active matrix method
Pixels
1 024 000
(1 280 x 800) x 3 panels
786 432
(1 024 x 768) x 3 panels
Lens
Manual zoom : 1.6x / Manual focus : F 1.6 to 2.12, f 15.30 mm to 24.64 mm
Luminous lamp
230 W UHM lamp
Light output *
1
3 700 lm 4 200 lm
Contrast ratio *
2
3 000 : 1 (all white / all black)
([LAMP POWER] is set to [NORMAL],
meanwhile [IRIS] is set to [ON])
4 000 : 1 (all white / all black)
([LAMP POWER] is set to [NORMAL],
meanwhile [IRIS] is set to [ON])
Appli-
cable
scanning
frequen-
cy *
3
for Video signal
(including S-
video)
Horizontal 15.75 kHz / 15.63 kHz, Vertical 60 Hz / 50 Hz
for RGB signal
Horizontal 15 kHz to 100 kHz, Vertical 50 Hz to 100 Hz
Dot clock frequency: 140 MHz or less
for YP
B
P
R
signal
[525i(480i)] Horizontal 15.75 kHz, Vertical 60 Hz
[525p(480p)] Horizontal 31.50 kHz, Vertical 60 Hz
[750(720)/60p] Horizontal 45.00 kHz, Vertical 60 Hz
[1125(1080)/60i] Horizontal 33.75 kHz, Vertical 60 Hz
[625i(576i)] Horizontal 15.63 kHz, Vertical 50 Hz
[625p(576p)] Horizontal 31.25 kHz, Vertical 50 Hz
[750(720)/50p] Horizontal 37.50 kHz, Vertical 50 Hz
[1125(1080)50i] Horizontal 28.13 kHz, Vertical 50 Hz
HD/SYNC and V terminals are not compliant with 3 value composite SYNC
for HDMI signal
525p(480p), 625p(576p), 750(720)/60p, 750(720)/50p, 1125(1080)/24p, 1125(1080)/24sF,
1125(1080)/30p, 1125(1080)/60p, 1125(1080)/50p, 1125(1080)/60i, 1125(1080)/50i
Displayable resolution: VGA to WUXGA (non-interlace)
Dot clock frequency: up to 162 MHz
Color system
7 (NTSC, NTSC4.43, PAL, PAL-N, PAL-M, SECAM, PAL60)
Projection size
0.76 m -7.62 m (30"-300")
Screen aspect ratio
16 : 10 4 : 3
Projection scheme
[FRONT/DESK], [FRONT/CEILING], [REAR/DESK], [REAR/CEILING] (Menu setting system)
Speaker
1 (4.0 cm round-type)
Maximum usable volume
output
10 W
These values of light output are measured under the condition that [LAMP POWER] is set to [NORMAL], [PICTURE *1
MODE] is set to [DYNAMIC]. Measurement, measuring conditions and method of notation all comply with ISO21118
international standards.
The value of contrast ratio is measured under the condition that [LAMP POWER] is set to [NORMAL], [PICTURE MODE] *2
is set to [DYNAMIC] and [IRIS] is set to [ON]. Measurement, measuring conditions and method of notation all comply with
ISO21118 international standards.
For details of video signals that can be projected using this projector, refer to “List of compatible signals”. *3
(Æpages 130-131)
132 -
ENGLISH
Chapter 6 Appendix - Specications