Panasonic PT-VW345NZU Projector User Manual


 
Adjust the image to t the screen according to the SCREEN FIT function's different states.
[FULL]
The aspect ratio will change to t the screen frame.
[ORIGINAL]
The aspect ratio will maintain to t the screen frame. The image may be displayed with the left and right/ top
and bottom parts cut off.
Then the COLORBOARD function is activated to get an optimal image. [CORNER CORRECTION] appears and it can be
adjusted manually if it is necessary (
Æ
page 64). It will exit without any operation in few seconds.
Screen frame undetected
If it does not detect a screen frame, the KEYSTONE function starts to work automatically and the keystone can be adjust
horizontally and vertically.
Then the COLORBOARD function is activated to get an optimal image. [KEYSTONE] appears and it can be adjusted manually
if it is necessary
(
Æ
page 63)
. It will exit without any operation in few seconds.
The conditions of SCREEN FIT function to adjust the projected image as follows.
Items Conditions
Projected image
40" - 100" (after correction)
Distance between projector and screen
approx. 0.9 to 3.5 m (when execute the keystone function, less than 2.5 m)
Correction angle
approx. 20° right and left /approx. 30° up and down
30°
20°20°
Attention
If the FOCUS ASSIST / SCREEN FIT / COLORBOARD function is working, please do not block some or all of the projected
f
image to interfere with the projected image, such as putting things before the camera which is on the front of the projector
body. Otherwise, the projected image will not be corrected properly.
Note
[SCREEN FIT] corrects the projected image when it detects two or more sides inside the projected area, and ts the
f
detected frame.
[SCREEN FIT] may not work well in bright environments and the projected image is in low contrast. In this case, make the
f
room darker, and then try executing [SCREEN FIT] again.
Because [SCREEN FIT] uses a sensor, it may not work properly depending on the condition of the projection surface
f
(deections, patterns, and so on), the distance between projector and screen, or the effects of outside light such as
uorescent. In this case, make the adjustments manually.
It is recommended to use a black frame screen when using SCREEN FIT function.
f
When the EASY SETTING function does not complete, [Projection situation is out of condition.] message will be displayed.
f
Please reconrm the setting status of the projector.
When the EASY SETTING function is executing, press the <EASY SETTING/CANCEL> button to exit, and then the next
f
function will execute.
When the EASY SETTING function is executing, press the <
f v/b
> button to exit, and then return to the previous state of the
running EASY SETTING function.
When the projector is mounted on a ceiling, do not use the EASY SETTING function. Otherwise it may not be adjusted
f
correctly.
When the COLORBOARD function is executed, [PICTURE MODE] will be switched to [EASY SETTING] mode automatically.
f
When you want to cancel the status of the running EASY SETTING function, please set from [EASY SETTING] mode to any
other mode of [PICTURE MODE].
(
Æ
pages 58)
When the SCREEN FIT function is executed, [KEYSTONE] or [CORNER CORRECTION] will be adjusted automatically.
f
When you want to ne-tune the keystone or cancel the status of the running EASY SETTING function, please adjust
[KEYSTONE] or [CORNER CORRECTION] manually.
(
Æ
page 63)
0.9 ~3.5 m
46 -
ENGLISH
Chapter 3 Basic Operations - Projecting