Filter
Top Products
– 106 –
Chapter 11 Maintenance and Inspection — Inspections before shooting
Inspections before shooting
Before shooting, perform the following inspections to ensure that the system operates properly.
1
Confirm that the assembled modules and the handles are fixed securely.
2
Mount the lens and adequately charged battery.
3
Insert an expressP2 memory card or P2 memory card into the main slot, and close the slot cover.
4
Set the <POWER> switch to <ON>.
5
Check the remaining battery level with the status display on the control panel.
If the remaining battery level is low, replace the battery with adequately charged one.
6
Check the media free space with the status display on the control panel.
7
Press the <REC> button and check the following.
fThe main slot card access LED ashes in orange.
fThe <REC> button lights up in red.
fNo system warning is displayed with the status display on the control panel.
8
Press the <REC> button again.
Conrm that the main slot card access LED lights up in orange and the <REC> button does not light in red.
9
Press the <PLAY> button to switch to the PLAY screen, and play back the clip you just recorded.
Conrm that the clip plays back properly on the control panel or viewnder.