Filter
Top Products
DCP Configuration
4-133920-A2-GN31-30 November 1996
Table 4-1
(4 of 9)
DTE Interface Configuration Options — Multiport Mode l
Rate at 7200
Nxt Disable 7200 4800 2400 1200
Rate at 7200. When the modem rate is 7200 bps the port rate will be as selected by this configuration option (Disable or
7200 to 1200). The total for all ports cannot exceed the modem rate of 7200 bps.
Rate at 4800
Nxt Disable 4800 2400 1200
Rate at 4800. When the modem rate is 4800 bps the port rate will be as selected by this configuration option (Disable or
4800 to 1200). The total for all ports cannot exceed the modem rate of 4800 bps.
Rate at 2400
End Disable 2400 1200
Rate at 2400. When the modem rate is 2400 bps the port rate will be as selected by this configuration option (Disable or
2400 to 1200). The total for all ports cannot exceed the modem rate of 2400 bps.
Port Async Sub-Group (One for Each Port)
Async/Sync Mode: Sync
Nxt Sync Async
Asynchronous/Synchronous Mode. Determines whether the port operates in Asynchronous mode or Synchronous
mode.
Async DTE Rate: =Sync
Nxt =Sync 150 300 600 1800
This configuration option only appears when Async/Sync Mode is configured for Async.
Asynchronous DTE Data Rate. Identifies the asynchronous DTE’s operating rate to the modem. The asynchronous rate
must be less than or equal to the synchronous port rate.
NOTE: When using 150, 300 or 600 bps line rates, the port rate must be set to a minimum of 1200 bps.
NOTE: When using 1800 bps line rate, the port rate must be set to 2400 bps.
=Sync – The asynchronous data is equal to the synchronous rate.
Asyn #Data Bits: 8
Nxt 8 7 9 6
This configuration option only appears when Async/Sync Mode is configured for Async.
Asynchronous Number of Data Bits. Determines if the asynchronous data length is composed of 6, 7, 8, or 9 data bits.
This data length excludes start, parity, and stop bits.
8
– Sets data length to 8 data bits.
7 – Sets data length to 7 data bits.
9
– Sets data length to 9 data bits
6
– Sets data length to 6 data bits.
Asyn #Stop Bits: 1
Nxt 1 2
This configuration option only appears when Async/Sync Mode is configured for Async.
Asynchronous Number of Stop Bits. Selects 1 or 2 bits to signal the end of an asynchronous character.