Filter
Top Products
COMSPHERE 392xPlus Modems
3-12 November 1996 3920-A2-GN31-30
Table 3-3
(2 of 3)
Top-Level Menu Status
Status IndicatesMessage
Call Failure Busy Signal The answering modem is busy.
Delayed
Number{
As a result of failed call attempts, this number can not be called at this time.
Please try again later.
Dial Line in Use The modem is operating on dial networks when another call attempt is
issued.
Forbidden
Number{
As a result of failed call attempts, this number can not be called again.
Invalid Number The modem has dialed a telephone number not stored in a directory
location.
Line Occupied{{
The line is being used by the associated telephone.
No Answer Tone The answering modem did not answer within the time limit specified by the
No Answer Timeout configuration option. The network tones (if any) could
not be interpreted by the modem.
No Dial-DTR The modem cannot dial because DTR is OFF.
No Dial-Test The modem cannot dial because it is running a Test.
No Dial Tone The modem has aborted the call because it cannot detect a dial tone.
No Quiet Answer The modem has detected No Quiet Answer (@) before the time-out setting
of the No Answer Disconnect configuration option.
Ringback
Timeout
The answering modem did not answer within the time limit specified by the
No Answer Timeout configuration option. A ringback signal was detected.
Trunk Busy The modem is receiving a fast (trunk) busy.
Wrong Call The call was answered, but not by a modem. No answer tone.
{ The Delayed Number and Forbidden Number messages appear only in countries where the number of repeat call
attempts are restricted. The regulations vary in each country. If the number is delayed, the value of the delay
(in minutes) can be displayed by entering Directory Status (see
Call Setup Branch
).
{{ The Line Occupied message appears only in countries where the Offhook Detector is enabled. The purpose of the
Offhook Detector is to detect whether the telephone associated with the modem is off-hook. It is enabled on a per
country basis, and this setting can not be changed by a command. The Offhook Detector is enabled in Austria,
Germany, and Switzerland.