Filter
Top Products
DCP Configuration
4-293920-A2-GN31-30 November 1996
Table 4-6
(2 of 3)
Miscellaneous Configuration Options — Multiport Mode l
Dir#1_Callback: Disable
Nxt Disable Enable
Directory Location 1 Callback. This configuration option controls whether or not the modem’s single number callback
function is used.
Disable – Modem does not use the single number callback function.
Enable – Modem answers a call, disconnects, and dials the number stored in directory location 1.
NMS_Call_Msgs: CallCnct&Prg
Nxt CallCnct&Prg Disable CallCnctOnly CallProgOnly
NMS Call Messages. Determines if the modem status and/or call summary information is sent to the NMS. The modem
can itemize status, such as CallProgress messages, or it can report a summary of activity, such as Call Connect
messages, to the NMS.
Call Connect & Progress – Enables both Call Connect and Call Progress information to be transmitted to the NMS.
Disable – Modem status and call summary information is not sent to the NMS.
Call Connect Only – The modem accumulates call statistics over a period of time and then transmits a summary of
these statistics to the NMS. The NMS uses this data to produce utilization reports.
Call Progress Only – The modem transmits detailed modem status information to the NMS. These messages include
any events that can display on the LCD.
NOTE: For 6800 Series NMS applications, Disable must be selected.
NetworkPosition: Tributary
End Tributary Control
Network Position Identification. Each modem must be identified either as a control modem or a tributary modem.
NOTE: Changes to this configuration option will cause the modem to reset.
NOTE: This configuration option is only applicable for leased-line network management applications.
For the Model 3920
Plus
, Tributary is the factory default.
For the Model 3921
Plus
, Control is the factory default.
NetMngmtAddress: 256
Nxt "
256
This configuration option is not available in point-to-point tributaries, which are always set to address 01.
Network Management Address. Determines the address used when accessing a modem from the NMS or when using
DCP functions that require network management addresses. Within a network link, a control modem can communicate
with a tributary modem by using the tributary modem’s network management address. Each TMp tributary modem must
have a different network management address. Address values range from 001 to 256.
NOTE: Changes to this configuration option will cause the modem to reset.