Filter
Top Products
COMSPHERE 392xPlus Modems
3-14 November 1996 3920-A2-GN31-30
Messages listed in Table 3-4 are common operational messages that occur during modem
operation. These messages normally appear on the second line of the LCD.
Table 3-4
Common Operational Messages
Common
Operational Message
Indicates
Please Wait... A command to a local device takes more than two seconds to complete.
Command Sent... A command is sent to a remote modem.
No Rem Response or
Remote Modem Fail
A remote modem does not respond to a command within 5 seconds.
Command Complete A command, issued to a local or remote modem, is completed.
Invalid Command The modem cannot complete a command.
Messages listed in T
able 3-5 are dial access security messages.
Table 3-5
Dial Access Security Messages
Dial Access
Security Message
Indicates
Get VF PsWd The answering modem is waiting for the originating caller to transmit a VF password.
Get DTE PsWd The answering modem is waiting to receive a valid DTE password from the remote DTE.
VF PsWd Timeout The modem did not finish answering a call (disconnected) because the allowed time limit
was exceeded before the modem received a VF password from the originating dialer.
Unknown DTEpswd The modem did not finish answering a call (disconnected) because the DTE passwords
received from the remote DTE were invalid.
No Orig PsWd The modem did not attempt to establish a call as requested because the A
T dial
command did not contain an originate access password.
Unknown VF PsWd The modem did not finish answering a call (disconnected) because the modem received
an invalid VF password.
DTEpswd Timeout The modem did not finish answering a call (disconnected) because the allowed time limit
was exceeded before the modem received a DTE password from the remote DTE.
Inval Orig PsWd The modem did not attempt to establish the call as requested because the originate
password in the AT dial command was not valid.
DTR Dial Blocked DTR dialing is not permitted when security is enabled. This message appears if DTR
dialing is used and Answer Access or Originate Access security is enabled.
SecurityBlocked The access verification capabilities are not available and the modem does not pass data
to the DTE under any circumstances. This message appears only when the modem is in
base mode (a mode that occurs during a firmware download) and Answer Access
Security is enabled.