Filter
Top Products
DCP Operation
3-213920-A2-GN31-30 November 1996
Displaying VF Conditions
F1
Status:VF
Display Clear
F2
F3
To
display VF conditions, select Display from the Status:VF screen.
F1
Status:VF >
SigQual=Excelent
F2
F3
If the modem is receiving a signal, the signal quality appears on the LCD’s bottom line. If the
modem is not receiving a signal, the message
No Signal
appears.
Press the
key to scroll and view the VF conditions.
NOTE
Not all conditions are available at 4800 bps.
SigQual Signal
Quality displays the condition of the VF line. Possible values are
Excelent (Excellent), Good, Fair, Poor, or
No Signal
. These parameters appear
for V.34, V.32 terbo, V
.32bis, and V
.32 modulations.
RcvLevel Receive Signal Level displays, in decibels referenced to one milliwatt (dBm),
the actual strength of the incoming signal. This parameter appears for V.34,
V.32 terbo, V
.32bis, V
.32, and Trellis Multipoint modulations.
Sig/Noise
Signal-to-Noise Ratio displays, in decibels, the receive signal strength relative to
noise on the line. This parameter appears for V.34, V.32 terbo, V
.32bis, V
.32,
and Trellis Multipoint modulations.
NrEchLvl Near End Echo Level displays the signal level, in decibels referenced to one
milliwatt (dBm), of that portion of the transmit signal which has been echoed
back by the local line termination. This parameter appears for V.34, V.32 terbo,
V
.32bis, and V
.32 modulations (in 2-wire only).
FarEchLvl Far End Echo Level displays the signal level, in decibels referenced to one
milliwatt (dBm), of that portion of the transmit signal which has been echoed
back by the remote line termination. This parameter appears for V.34,
V.32 terbo, V
.32bis, and V
.32 modulations (in 2-wire only).
FarEchDel Far End Echo Delay displays the roundtrip delay in milliseconds of the far end
echo. This parameter appears for V.34, V.32 terbo, V
.32bis, and V
.32
modulations (in 2-wire only).