Filter
Top Products
5. Testing
8784-A2-GB20-30 February 2001
5-5
DTE Loopback
A DTE Loopback loops the DSX-1 signal back to itself before the signal is sent to
the Framer.
Procedure
To run a DTE Loopback:
1. Position the cursor at the Start command next to DTE Loopback on the
Network & DSX-1 Tests screen.
2. Press Enter.
The Start command is changed to Stop.
3. To manually stop the test, verify that the cursor is positioned at the Stop
command.
4. Press Enter.
The DTE Loopback cannot be started when any other loopback test is in progress.
CAP
DSL
Port
DSX-1
Port
CAP T1
LIU
FramerFramerTransceiver
98-16110
All Ones