Patton electronic Model 2604 Network Card User Manual


 
16 • System Log T1/E1 DACS Administrators’ Reference Guide
110 System Log—Modify
Min Priority for SysLog Daemon (syslogDaemonPriority)
System messages which have a priority equal to or greater than this setting will be sent to the syslog daemon
defined by the SysLog Daemon IP Address (syslogDaemonIP).
prioritySystem(80)
priorityDisable(1000)
Min Priority for Console RS-232 (syslogConsolePriority)
System messages which have a priority equal to or greater than this setting will be sent directly to the RS-232
Config Port on the rear of the 2604. Messages will be sent regardless of the current operating state of the RS-
232 configuration port. The lower the number next to the priority listed below, the more details system logging
will provide.
priorityVerbose will generate the most messages, while priorityDisable will turn off all messages.
priorityVerbose(5)
priorityDebug(10)
priorityInfo(20)
priorityOddity(40)
priorityService(60)
prioritySystem(80)
priorityDisable(1000)
Min Priority for Flash Storage (syslogFlashPriority)
System messages which have a priority equal to or greater than this setting will be permanently stored in the
Flash PROM. Due to being permanent memory, the Flash memory eventually becomes filled. When this
occurs, the memory must be cleared before accepting more messages. Some maximum number of messages
may be stored in the Flash PROM before this storage area must be cleared.
prioritySystem(80)—Flash PROM will be used to store system-level messages.
priorityDisable(1000)—No messages will be stored.
Min Priority for SNMP Trap Daemon (syslogTrapPriority)
System messages which have a priority equal to or greater than this setting will be sent to the SNMP Trap Dae-
mon IP Address (syslogTrapIP). The lower the number next to the priority listed below, the more details system
logging will provide.
priorityVerbose will generate the most messages, while priorityDisable will turn off all
messages.
priorityVerbose(5)
priorityDebug(10)
priorityInfo(20)
priorityOddity(40)
priorityService(60)