Filter
Top Products
C2904M-B (2/05) 23
MOUNTING TWO UNITS
Figure 17. Mounting Two Units
Refer to Figure 17. Use the two short angle brackets and two rails from the mounting kit. The two units must first be bolted together. Do
the following:
1. Turn the two units upside down. Lay them alongside each other and secure the two rails to the units using four supplied chrome
screws for each unit. Turn them right side up.
2. Screw the two short angle brackets to the outside of the two units using the four supplied small black screws.
3. If necessary, remove the rubber feet from the unit’s base if other equipment will be mounted directly underneath.
4. Mount the units in the rack and secure the angle brackets using four screws. (Leave cooling space of two inches [5 cm] on left and
right sides and 4 inches [10 cm] at the rear.)
5. Plug the supplied power cables into the Power sockets on the rear of the units.