Filter
Top Products
VI. Configuring Administrator’s Data at Homepage
This page allows the VersaCam Administrator to login and configure the camera remotely. This
page may also be accessed by keying in the VersaCam’s IP address and clicking the ‘Start
Configuration’ button from the Setup program.
A. Administrator Login
1) Accessing through the Setup Program
First, click on the MAC address to select the desired VersaCam. Then key in its
administrator’s password and click the ‘Start Configuration’ button. When you click the
‘Start Configuration’ button, the setup program automatically connects you to the Admin
page of the VersaCam IC Series. (For more detailed information, refer to Chapter
IV
‘Assigning IP address and Configuring Administrator’s Data’)
2) Accessing through Web Browser
Using a Web browser, an administrator
can key in the IP address of the VersaCam
IC-360 that they are going to configure.
Then the administrator accesses the
VersaCam IC-360 login page. At the
login page, the administrator should key
in the administrator’s ID and password to
access the Admin page.
The administrator may also access the
VersaCam IC-360’s real-time image
viewer, and then access the Admin page
by clicking the ‘Goto Admin Page’ button.
The two login pages look a bit different,
but the administrator can access the Admin page though both login pages.
The default administrator’s ID and password are set to ‘admin’ and the administrator may change
them at the Admin page. Note that each ID and password must be composed of up to 9 letters and
numbers. Note that both
are case sensitive.
VersaCam IC-360 User’s Guide
20