Filter
Top Products
5) Video Configuration
This page allows configuration of every
channel with various conditions.
(1) Video Channel State Control
The administrator decides whether to
utilize the video signal from a particular
video channel of the VersaCam. For
the IC-360 model, there is only a single
video channel available, so this button
serves only to enable or shut down this
channel.
(2) Camera Color Type
This button is used to define whether the camera internal to the IC-360 is a color or black & white
camera. At this time, ALL IC-360 units employ color cameras. Therefore, this setting must be
left in the “Color” position.
(3) Video Signal Type
This button is used to define the type of internal CCD module and external CCD cameras (not
available on the IC-360) as either ‘NTSC’ or ‘PAL’ format. As the VersaCam IC-360 cameras are
built as either one or the other, this setting should not be changed.
(4) Camera Installation Angle
This feature allows for automatic image rotation for cameras that are not installed “right side up.”
The IC-360 model can be installed base up on a ceiling (where this option is set to “Normal”) or
with the base down on a table or other surface with the dome pointing up (where this option is set to
“180 deg”).
(5) Advanced Configuration
By Clicking ‘Advanced Configuration,’
you may access the page where
advanced configuration details can be
set.
Calibration Parameters
The administrator may manipulate the
image by adjusting brightness, contrast,
hue, saturation, horizontal line shift, and
vertical line shift from this menu. The
default setting for all controls is “0.”
Immediate feedback of the results of
each change is available in the image
viewing area after confirming that the
administrator wishes to make the
change by clicking the “Apply” button
at the bottom of the page.
Caption Display Options
The administrator can set the default
captioning information to be displayed,
if any, on the transmitted image.
VersaCam IC-360 User’s Guide
26