Filter
Top Products
Appendix 4
Appendix 4 - Updating VersaCam IC-360 Firmware
Warning
This process is for updating the current firmware that is already installed into your
VersaCam 360 with new updated firmware.
To begin the process, wait until the ‘Loading complete’ message appears. During the
process, do not disturb the VersaCam or disconnect network lines or power. Otherwise,
your VersaCam can be damaged, which may result in inappropriate operation or
operational failure.
If you fail to completely update the VersaCam firmware or the VersaCam does not operate
properly after the updating process, contact your distributor or Pentax Customer Service.
1. Connect VersaCam 360 to a PC.
When you update your firmware, it is strongly recommended that you connect your VersaCam to a PC
directly* using a crossover cable.
Crossover cable
If a crossover cable is not available, you may perform the update with a direct cable connected a HUB
(LAN). When you perform an update via a LAN, your VersaCam and PC should be connected on local
network.
Direct cable
* You may also update the firmware via a remote network.
VersaCam IC-360 User’s Guide
55