Filter
Top Products
SV60890 Rev. G 9-5
DM500™and DM550™ Digital Mailing System Operating Guide
E-Z Seal
®
Sealing Solution
Maintenance
1. Open the feed cover and lift out
the E-Z Seal® bottle.
The bottle is located to the left
of the tape roll.
E-Z Seal
®
Bottle
Your mailing system displays a message telling you when your E-Z Seal®
Solution is running low. When you receive this message, your system can
still seal approximately 50 envelopes.
CAUTION: Pitney Bowes recommends using E-Z Seal®
Solution because it helps keep your moistener tank clean and
improves sealing efficiency. To order E-Z Seal® Solution, refer to
Chapter 11, Supplies and Options in this guide.
2. Remove the cap from the bottle.
3. Add enough E-Z Seal® to bring
the level up to the bottom of the
fill cap.
CAUTION: Do not overfill the E-Z Seal® Bottle
CAUTION: Make sure you do not spill any solution in the tape
well. If the tape gets wet, it can warp and cause a jam.
4. Replace and tighten the cap and replace the bottle. The nozzle should
be facing down and the flat side of the bottle facing the front of the sys-
tem.
5. Close the feed cover.