Filter
Top Products
9-10 SV60890 Rev. G
9 • Maintaining and Updating
Cleaning or
Replacing the
Wick
continued
10. Place the shield and wick
assembly in the moistener
tank and push down on
the shield to push the as-
sembly into the tank.
11. Replace the moistener tank
and gently slide it back into
the machine, taking care not
to crimp the supply tubing. Do
not push the tank all the way
back into the machine yet.
12. Replace the E-Z Seal
®
Seal-
ing Solution bottle. Wait for
about 5 minutes and then
check to make sure the
moistener tank is filled with
the correct amount of E-Z
Seal® solution. Measure the
amount of solution as shown
in the diagram on the right.
The solution level should be:
14 - 18 mm (0.55 - 0.71 in.)
If, after 5 minutes, the moistener tank is not filled to the correct level,
remove the E-Z Seal® bottle, wait 20 seconds and then replace it
again.
If after another 5 minutes the level is still not correct, go to step 13.
Otherwise go to step 14.
Solution level