Filter
Top Products
NetEngine IAD User Guide
WAN Configuration 90
Configuring
ATM
Options
To configure ATM options, type 4 to display the ATM Configuration menu:
Figure 4–54. ATM Configuration Menu
To perform these tasks, type the option and proceed to the corresponding
section. The tasks in this section are described beginning at the ATM
Configuration menu.
Configuring Payload Scrambling (following)
Configuring F4 OAM VPI (page 90)
Configuring F4 OAM Type (page 91)
Displaying F4 OAM Configuration (page 91)
Sending OAM Loopback (page 91)
Configuring EmptyCells (page 92)
Configuring Payload Scrambling
You must enable payload scrambling (which is disabled by default) for the
IAD to connect to a DSLAM that uses payload scrambling.
To enable or disable payload scrambling:
1. On the ATM Configuration menu, type 1 to select Configure Payload
Scrambling.
2. The IAD displays the status and a prompt:
Payload scrambling is DISABLE
Enter E to Enable, D to Disable:
To enable payload scrambling type E, or type D to disable payload
scrambling.
3. The IAD saves the configuration and displays the ATM Configuration
menu where you may continue with other ATM tasks.
4. Reset the IAD (page 15) when you finish ATM configuration.
Configuring the F4 OAM VPI
One one F4 OAM VPI may be configured at a time. When you are
configuring an F4 OAM VPI, if one is not configured, the IAD displays the
message, “F4 OAM not configured”; otherwise the current configuration is
displayed.
To configure the F4 OAM VPI:
1. On the ATM Configuration menu, type 2 to select Configure F4 OAM
VPI.
*****************************************
ATM Config Menu
*****************************************
1. Configure Payload Scrambling
2. Configure F4 OAM VPI
3. Configure F4 OAM Type
4. Display F4 OAM Configuration
5. Send OAM Loopback
6. Configure EmptyCells