Filter
Top Products
NetEngine IAD User Guide
Router Configuration 113
Removing a Static Route
To delete a static route from the Route Table:
1. On the Router Modification menu type R to select Remove a Route.
2. The IAD prompts for the address of the route to remove:
Enter address of static route to remove:
Type the IP address of the route to remove and press Enter.
3. The IAD removes the route from the table and the IAD displays the
Router Modification menu.
4. Repeat these steps for each route that you want to remove.
5. Continue with other configuration tasks, or press Escape to return to
the Main menu.
6. Reset the IAD (page 15) when you finish router configuration.
Setting the
Default
Route
Adding or Changing the Default Route
To add a default route on the WAN, or change the current default route:
1. On the Router Modification menu type F to select Add/Change the
Default Route.
2. The IAD prompts for the default gateway address. (You may press 0
for a list of interfaces):
Enter Default Gateway address, or 0 to pick an
Interface:
Type the default gateway address and proceed to step 3.
-or-
Type 0 to display the port table:
Select default IP interface.
Port VPI VCI Encapsulation Type PCR Service
1 0 40 RFC 1483 (with LLC Encap)3641 UBR
Total = 3641 cps
Maximum PCR this interface can support = 3622 cps
Select Port: [1-8]
Type the port to select and press Enter.
3. The default route is set and the Route Table is updated.
4. Continue with other configuration tasks, or press Escape to return to
the Router Modification menu.
5. Reset the IAD (page 15) when you finish router configuration.
Removing the Default Route
To remove the default route from the Route Table:
1. On the Router Modification menu type T to select Remove the Default
Route.
2. The default route is immediately deleted and the Route Table is
updated.
3. Continue with other configuration tasks, or press Escape to return to
the Router Modification menu.
4. Reset the IAD (page 15) when you finish router configuration.