Filter
Top Products
NetEngine IAD User Guide
Quick Start Guide 13
7. Type the default password (supervisor, or your password if
different) and press Enter.
8. If log in is not successful, the IAD displays the following message:
Invalid UserID or Password - Try again
Press any key to continue...
9. Press any key, and repeat the log in sequence. If you cannot log in,
call your support provider for assistance.
When you first log in, the IAD displays the Main menu. The menu may
vary, depending on the IAD.
Figure 2–1. Main Menu
Setting the Ethernet Port IP Address
Before you configure the Ethernet IP address, you should know the IP
address and subnet mask that is to be assigned to this port. It may be
displayed on the work order, or you may obtain or determine the
appropriate IP address by consulting with the network administrator.
The IAD is shipped with a null IP address and subnet mask. To configure a
port IP address:
1. On the Main menu, type 2 to select Configure IP Router.
2. The IAD displays the Router Configuration menu.
*****************************************
Main Menu
*****************************************
1. Reports Menu
2. Configure IP Router
3. Configure Bridge
5. Configure WAN
6. Configure LAN
7. Configure SNMP
8. Configure Login
9. System Utilities
D. Configure DHCP Server
M. Configure Multicast
N. Configure NAT
T. Telephony Clock Recovery
Z. Diagnostics Menu
C. Command Line Interface
R. Reset System
P. Voice Path Configure
E | A | O. CopperCom Call Control
Options E, A and O
vary, depending on the
voice gateway selected
in the Voice Path
Configure command.