Filter
Top Products
NetEngine IAD User Guide
Router Configuration 104
Basic
Router
Setup
Tasks
To configure the IAD as a router, you should complete the following tasks:
Configure IP addresses on the LAN and WAN ports (page 106)
Enable RIP poisoned reverse (recommended—page 110), add a static
route (page 112), or add a default route (page 113)
Disable bridging globally (page 132) or by port (page 133)
Disable Spanning Tree Protocol (STP) globally (page 134) or by port
(page 134)
Use this flowchart to plan your tasks, based on your router configuration
requirements.
Figure 5–1. Router Configuration Task Flowchart
Main
Menu
Ye s
Ye s
Enable
bridging
interface
per port
End
Enable RIP
globally
All interfaces
configured
with IP?
No
No
Using default
route?
Define IP for
each interface
per port
End
End
Add default
route to
routing table
Configure
RIP version
by port
Enable
global
bridging
Add static
route to
routing table
Using
RIP?