Filter
Top Products
NetEngine IAD User Guide
Voice Path Configuration 140
Basic Voice
Path Setup
Tasks
To configure voice path settings, you should complete the following tasks:
Select a voice gateway (page 141)
Set the jitter delay (page 142)
Set start mode (page 143)
Set Compander mode (page 145)
Set echo cancellation (page 147)
Set loop gain (page 148)
Set bandwidth tone (page 150)
Voice Path
Configur-
ation Menu
Configuring the voice path settings involves several tasks. These are all
displayed and accessed on the Voice Configuration menu (displayed by
typing P on the Main menu).
Tasks in this chapter are described beginning at the Voice Configuration
menu.
Figure 7–1. Voice Configuration Menu
*******************************************
Voice Configuration
*******************************************
V. Set Voice Gateway
J. Set Jitter Delay
D. Display Jitter Delay
S. Set Start Mode (Loop Start/Ground Start)
T. Set SLIC Control Mode
U. Set Compander Mode (u-Law, A-Law)
O. Set On Hook Transmission Mode of Ground Start Lines
L. Set Idle Voltage Mode of Loop Start Lines
M. Set Debug Mode
E. Configure Echo Cancellation Default Settings
G. Set Loop Gain
C. Set Country Mode
NOTE
You must sign on as Supervisor to configure voice path
settings.
Be sure to reset the IAD when you are done making changes
to the voice path settings. Resetting the IAD causes the
configuration changes to take effect.