Polycom 7000 Network Router User Manual


 
NetEngine IAD User Guide
WAN Configuration 94
Adding a DLCI
To add a DLCI:
1. On the Frame Relay DLCI Configuration menu, type 1 to select Add
New DLCI.
2. The IAD displays the following prompt:
Enter dlci number:
Type a DLCI value between 16 and 1023 (default is 32 for data and 33
for voice) and press Enter.
3. The IAD displays the FR Encapsulation Configuration menu:
Figure 4–57. Frame Relay Encapsulation Configuration Menu
Type the option corresponding to the encapsulation method you intend
to use.
4. The IAD displays the FR DLCI Options menu:
Figure 4–58. Frame Relay DLCI Options Menu
Configuring Transmit CIR
To set up Configure Transmit CIR, type 1 to select Configure Transmit
CIR.
5. The IAD displays the Bc prompt:
Enter the committed burst size (Bc) in number of
bits (0):
Type the committed burst size.
*****************************************
FR Encapsulation Configuration
*****************************************
Current Encapsulation: None
1. RAW (No Encapsulation)
2. Proprietary Voice DLCI
3. RFC 1490
4. ATM RFC 1483 (Tunneling)
*****************************************
FR DLCI Options
*****************************************
Current Encapsulation: None
1. Configure Transmit CIR
2. Configure Receive CIR
3. Configure FRF.12 Fragmentation
NOTE
To continue without configuring CIR or FRF.12
Fragmentation, press Escape. CIR is not required for bull
bandwidth circuits.