Filter
Top Products
NetEngine IAD User Guide
WAN Configuration 93
Configuring
Frame
Relay
DLCIs
To configure Frame Relay DLCIs, type 3 on the WAN Configuration menu.
The IAD displays the Frame Relay DLCI Configuration menu:
Figure 4–56. Frame Relay DLCI Configuration Menu
To perform these tasks, type the option and proceed to the corresponding
section. The tasks in this section are described beginning at the FR DLCI
Configuration menu.
Adding a New DLCI (Adding a DLCI on page 94)
Modifying an Existing DLCI (Modifying a DLCI on page 93)
Deleting a DLCI (Deleting a DLCI on page 96)
Showing Current DLCIs (page 96)
You may configure up to 8 DLCIs on the IAD.
Modifying a DLCI
To modify a DLCI:
1. On the Frame Relay DLCI Configuration menu, type 2 to select Modify
Existing DLCI.
2. The IAD displays the port list and prompt:
Port DLCI Encapsulation
---- ----- -------------
1 16 RAW (No Encapsulation)
Select Port: [1-8]
Type the port number corresponding to the DLCI you want to update.
3. The IAD prompts you for the DLCI:
Enter dlci number [16]:
Type the DLCI number to change and press Enter.
4. The remainder of this task is identical to the steps in Adding a DLCI,
following. Proceed to step 3 in the next section and continue.
*****************************************
FR DLCI Config Menu
*****************************************
1. Add New DLCI
2. Modify Existing DLCI
3. Delete DLCI
4. Show Current DLCIs
NOTE
Before you configure DLCIs, you must first set the datalink
protocol to Frame Relay. If option 3 on the WAN
Configuration menu displays Configure PVCs instead of
Configure DLCIs, your datalink protocol is set to ATM instead
of Frame Relay.