Filter
Top Products
NetEngine IAD User Guide
WAN Configuration 72
Configur-
ing the T1
Interface
The tasks described in this section all begin on the T1 Configuration menu.
The tasks as described so you can proceed through them sequentially.
You should review and update each of these options as necessary, and
reset the IAD when you finish WAN configuration.
To configure the T1 interface, Type 2 (Configure Physical Interface) on the
WAN Configuration menu to display the T1 Configuration menu:
Figure 4–24. T1 Configuration Menu
Selecting Frame Mode
1. Type 1 to select Frame Mode (D4 or ESF) and display the T1 Frame
Mode menu:
Figure 4–25. Select T1 Frame Mode Menu
Type 1 to select ESF Frame Mode, or 2 to select D4 Frame mode.
2. The IAD resets the interface and displays the menu.
3. Press Escape to return to the T1 Configuration menu.
4. Continue with other configuration tasks.
5. Reset the IAD (page 15) when you finish T1 configuration.
LAN LINK LAN ACT WAN LINK VOICEPOWER
6200-8
7216
This section is for configuring the T1 interface on the 6200-8
or 7216 IAD.
*******************************************
T1 Configuration Menu
*******************************************
1. Select Frame Mode (D4 or ESF)
2. Select Transmit Line Build Out
4. Select B8ZS or AMI
5. Configure Loopback
6. Configure Transmit Channels
7. Configure Receive Channels
8. Configure Transmit Clock Source
9. Change to E1 Mode
**********************************
Select T1 Frame Mode
**********************************
T1 Frame Mode Is ESF
1. ESF Frame Mode
2. D4 Frame Mode