Backup/Restore Configuration Settings
Quantum TC2201 User’s Guide 125
ftp <IP address>
The default IP address is 1.1.1.1.
3 Enter the user name and password. The default values for user name
and password are root for the user name and password for the
password.
4 Specify binary mode:
bin
5 Specify the configuration’s path and filename (.cfg file) with the put
command:
put <path:filename.cfg>
The file will transfer and the TC2201 will reboot. The TC2201 will then be
using the configuration.
Note: If the TC2201 is to use a static IP address, the default IP
address 1.1.1.1 should be changed to an address that is
appropriate for the IP network it will reside on. Note that the
default IP address can be used in a direct connection between
the TC2201 and the host computer via a crossover Ethernet
cable.
Note: World Wide Name (WWN) values and Ethernet physical
address (MAC address) values will revert to the factory
default settings. Any user defined values for these settings are
not retained and must be re-entered after a configuration is
restored. See the Configuration Backup Procedure earlier in
this chapter for more information.
Note: You should confirm the new configuration by checking that
the settings are correct.
