Filter
Top Products
Chapter 2 TC2201 Web Interface
SCSI Bus Page
Quantum TC2201 User’s Guide 28
Figure 20 SCSI bus Configuration
Page
• Primary Initiator ID must be assigned an Initiator ID. This ID should be
a unique ID on the bus. The default setting is 7.
• Discovery enables/disables device discovery on this SCSI bus. The
default setting is
Enabled.
• Discovery Delay is the time in seconds that the TC2201 waits after a
power-up or reboot process (which typically takes approximately 2
minutes) before starting to discover SCSI devices. Quantum
recommends you set the value to at least 2 seconds to ensure all SCSI
devices complete their individual power-ups. However, the user
should be aware this delay is added to the time it takes for the
TC2201 to reboot and for QVM to be active again. The default setting
is 2 seconds.
• Bus Reset on Boot enables/disables automatic discovery of SCSI
devices after an initial power up or reboot of the TC2201. The default
setting is
Enabled.
• Override Settings are provided to enhance inter operability with some
storage devices that require special consideration during setup of the
TC2201. Access to the Overrides Settings is reserved for authorized
Quantum technicians. Selecting the
Go button opens a login prompt
for which an authorized technician should have the appropriate user
name and password (see
figure 21).