Filter
Top Products
Perform Configuration
Quantum TC2201 User’s Guide 77
Table 12 Figure 7-5:
Ethernet Configuration
Menu
Select the Enter key to toggle to the next Ethernet port, such as to
configure settings for one of the iSCSI ports.
•Select 1 to toggle the DHCP setting. This setting enables/disables
support for Dynamic Configuration Protocol. When enabled, the
TC2201 will retrieve a dynamic IP address from a DHCP server
located on the Ethernet network that the TC2201 is connected to.
Once DHCP is enabled, it is necessary to
save the current
configuration and
reboot the TC2201 before an IP address will be
requested from the DHCP server. Use the following four steps:
Ethernet Configuration Menu
X.XX.XXXX XXXXXX XXXXXXXXXXXXXX
07/26/2005 08:56:22
Port Type : 10-100 Ethernet
IP Address : 192.168.100.159 [DHCP Enabled]
Subnet Mask : 255.255.255.0
Gateway(s) :
MAC Address : 00:E0:02:E3:13:94
Ethernet Mode : 10/100Mbps (Auto-Neg)
Ethernet MTU Size : 1500
1) Toggle DHCP Configuration
2) Change IP Address
3) Change Subnet Mask
4) Change Gateway
5) Change Ethernet MAC Address
6) Change DNS Settings
7) Change Ethernet MTU Size
X) Return to previous menu
Command, <enter> for next port >