Update Firmware
Quantum TC2201 User’s Guide 127
Update Firmware 4
Using the following procedure, FTP can be used to update the TC2201
firmware.
1 Connect the TC2201 to the Ethernet network used by your computer.
2 Start your FTP program using the TC2201’s IP address:
ftp <IP address>
The default IP address is 1.1.1.1.
3 Enter the user name and password. The default values for user name
and password are
root for the user name and password for the
password.
4 Specify binary mode:
bin
5 Specify the firmware’s path and filename (.dlx file) with the put
command:
put <path:filename.dlx>
The file will transfer and the TC2201 will reboot. The TC2201 will then be
using the new firmware.
Note: If the TC2201 is to use a static IP address, the default IP
address 1.1.1.1 should be changed to an address that is
appropriate for the IP network it will reside on. Note that the
default IP address can be used in a direct connection between
the TC2201 and the host computer via a crossover Ethernet
cable.
Note: You may want to confirm the new firmware level by checking
the reboot messages on the TC2201 through the serial port.
