Filter
Top Products
30
STORING
FREQUENCIES
INTO CHANNELS
1. To begin programming your
scanner, press
FUNC, and
then
CAR to change the
channel display mode.
MAN, a
bank and channel number
appears on the display. You
can select the desired
channel storage bank and
channel using the number
keys and
SCAN. For example,
Bank 3, Channel 23 is
entered as "323" and SCAN.
2. Use the number keys and
./
CLEAR to enter the
frequency (including the
decimal point) you want to
store.
3. If you make a mistake, press
and hold ./
CLEAR for about 2
seconds to clear the entire
field and start over.
4. Press ENT to store the
frequency into the channel.
If you made a mistake in
entering the frequency,
Invalid Freq. briefly appears
and the scanner beeps when
you press
ENT. Enter the
frequency again.
If you enter a frequency that
has already been entered
elsewhere in the same bank,
the scanner sounds an error
tone.
Dupl.Freq. and the
channel number that has
been duplicated displays. If
the dual entry is an error,
Ô NOTES Ô
• Your scanner
automatically rounds
the entered
frequency to the
nearest valid
frequency. For
example, if you enter
a frequency of
151.53, your scanner
accepts it as
151.5275. Reception
of the frequency will
not be adversely
affected.
• You may replace any
frequency by
selecting the bank
and channel,
pressing ß or Ü and
entering the new
frequency.
• You can clear
programmed
frequency data.
Press 0 then ENT
.
20-515Change01_04.fm Page 30 Friday, January 16, 2004 1:14 PM