Filter
Top Products
34
INITIALIZING THE
SCANNER
If you want to clear all the
scanner’s memory, initialize the
scanner.!
1. Press and hold FUNC for
about 2 seconds.
2. Press
8, 5, and then ENT.
Do not turn off the scanner
until the initialization is
complete.
SCANNING
CHANNELS
1. Set the scanner to the
conventional channel mode
so MAN, Bank, and a frequency
appear by pressing
FUNC
then
CAR.
2. Turn
SQ fully
counterclockwise and adjust
VOL to a comfortable level.
3. Turn SQ clockwise until the
rushing sound stops.
To begin scanning channels or to
start scanning again after
monitoring a specific channel,
press
SCAN.Ô
To change the scanning direction,
press
^
or v while scanning.
To restart scanning while the
scanner is in stop mode, press
^
or
v
.
The scanner scans through all
channels (except those you have
locked out) in the active channel
storage banks (see “Turning
!
IMPORTANT
!
Initializing the scanner
clears all information
you stored in the
scanner’s memory.
Initialize the scanner
only when you are sure
.
Ô NOTES Ô
• The scanner will not
enter scan mode if
there are no
frequencies stored in
channels, or if all
channels are locked
out in the channel
storage bank(s) that
you are attempting to
scan. In either of
these cases, the
scanner will display
All channels Locked out!.
See “Storing
Frequencies Into
Channels” on
Page 30
• If SQ is adjusted so
you always hear a
rushing sound, the
scanner will not scan
properly. Rotate the
SQ control until the
rushing sound stops.
• If SQ is adjusted
precisely at the
threshold where the
rushing sound stops,
the radio will be most
sensitive to very
weak signals. The
radio may also
receive unwanted
noise or signals that
are too weak to
understand. Most
users prefer to
position the SQ
control a little bit past
the point of threshold
to avoid receiving
noise or signals that
are too weak to
understand.
20-515Change01_04.fm Page 34 Friday, January 16, 2004 1:14 PM