Filter
Top Products
CHAPTER 2: OPERATION 31
6. Click Close to quit the dialog.
Note about “Reset to Defaults”
You can click Reset to Defaults to save time configuring the source association data when the
Paragon channel ports and the router’s source ports are associated with each other based on the
same port numbers. The command has these characteristics:
• All existing source association data is cleared and replaced by new data.
• All channel ports will be associated with source ports based on identical port numbers. That
is, channel port 1 is associated with source port 1, channel port 2 with source port 2, channel
port 3 with source port 3, and so on.
• The number of associated ports is determined according to the number of channel ports.
• Port type is set to audio by default.
Configure User Stations
User ports on a Paragon switch connect to user stations, and destination ports (output connectors)
on a NV5128 router connect to audio/video input devices. To determine which audio/video input
devices should receive the audio/video signals transmitted by the router, you must associate user
ports with destination ports. Usually your association settings should be able to direct the
audio/video signals to the audio/video input devices located near a user station. A user port can be
associated with a maximum of 8 destination ports, and each destination port can be associated
with one user port only.
Adding Destination Association Data
1. Choose Router > Configure User Stations. The Configure User Stations dialog appears.
Figure 32 Configure User Stations Dialog
2. Click New to start adding destination association data.
3. Click the UMT Name drop-down arrow and select the Paragon Base Unit to which the
Paragon Manager is connecting.
4. Click the User Port drop-down arrow, and select the user port on the Paragon switch that you
want to associate with the router’s destination port(s).
5. Click the Router Name drop-down arrow and select the NV5128 router whose destination
ports you want to associate. The router must be the same one that you selected in the
Configure Servers dialog.
6. This step varies depending on your physical hardware configuration:
• To associate all ports based on identical port numbers:
a. Click Reset to Defaults.