Filter
Top Products
SAFETY SUMMARY (Continued)
Safety 4
II L 00
• Unplug the Power Supply Cable prior to connecting.
(Section 4.1,Page 4-4)
• Be careful not to have other personnel plug in the power cable while performing the connecting.
(Section 4.1,Page 4-4)
• Be sure to use power supply cable which complies with the following specification :
Power plug rating ; Min. AC 250V, Min. 15A (2-Pole, 3-Wire, Grounded)
6-15P UL Listed, CSA Certified in North America
Type CA, Conformed to IEC 950 in Europe
Power cable rating ; Min. AC 250V, Min. 15A
Type SJT or SVT, UL Listed, CSA Certified in North America
Conformed to IEC 950 in Europe
(Section 4.1,Page 4-4)
• Use the Power Supply Cable which is approximately 50 mm longer for the FG. The cable should be
designed as below, so the FG power cable remains connected if the other cables are accidentally
disconnected.
(Section 4.1,Page 4-4)
• Make sure that the power cables are connected to the correct terminals (“L”, “N” ) on the power plug
and Terminal Block. ( FG power cable is connected to chassis.)
(Section 4.1,Page 4-4)
• The socket-outlet shall be installed near the printer and be easily accessible.
(Section 4.1,Page 4-4)