Filter
Top Products
Preparation for Installation 4-43
II L 00
13) Connect the FNS IF cable (4 pin white connector) coming from the Container Stacker 2 to
the 4 pin white connector in the Finisher (Connection 1 on the below figure).
14) Connect the FNS IF cable (20 pin black connector) coming from the Container Stacker 2 to
the CN7 connector on the Finisher main P/K (Connection 2 on the below figure).
15) Turn on the No. 5 and 8 and turn off the No. 2 of the SW1 mounted on the CPXXX P/K of the
Engine.
Turn on the No.8 and Turn off the No.7 of the SW2 mounted on the CPXXX P/K of the
Engine.
Turn on the No.2 and 4 of the SW1 mounted on the ST09X P/K of the Container Stacker 2.
Turn on the “L” of the SW1 mounted on the P/K of the Standard Finisher(FS-108R).
[Note] Put the cable through the opening “A” of the Container Stacker 2 for connection.
16) Install the Rear Covers of the Printer, Container Stacker 2 and Finisher.
Opening “A”
Printer
Container Stacker 2
(W/ Through path)
Standard Finisher
AF cable
Connection 2
(20 pin black)
Connection 1
(4 pin white)
Disconnection 1
(4 pin white)
Disconnection 2
(2 pin white)
II L 01
H
L
SW1
8
7
6
5
4
2
3
1
MKK
ON
OFF
OFF
SW1
8
7
6
5
4
2
3
1
MKK
ON
OFF
OFF
SW2
4
2
3
1
MKK
O
FF
OFF
O
N
SW1