Filter
Top Products
Colour Functions
43
2
F Selects the new Colour to be converted.
You can adjust the density of each Colour in four steps.
To select User Colour, press [User Colour], and then select the Colour.
G After selecting all Colours to be converted, press [OK] three times.
H Place the originals, and then press the {Start} key.
Note
❒ The width of the Colour to be converted can be adjusted in five levels. If
the Colour width is set to [Wider] and red has been specified, Colours,
which are close to magenta or orange, will also be converted. The Colour
width can be adjusted in User Tools. This adjustment will be valid in
“Erase Colour”. See “Colour Sensitivity”, General Settings Guide.
❒ When you want to change the converted Colour in step
F
, press from [Con-
version 1] to [Conversion 4] and make the selection again.
❒ When changing between more than two Colours, repeat steps
D
to
F
.
❒ The full Colour counter will advance to “1”.
Erase Colour
Copies by erasing a certain Colour in the image of the original.
A Press [Edit / Colour].
B Make sure that [Colour] is selected before pressing [Erase Colour].
C Select the Colour to be erased.
It is possible to select up to 4 Colours.
D After selecting all Colours to be erased, press [OK] twice.
E Place the originals, and then press the {Start} key.