Filter
Top Products
T
ROUBLESHOOTING
8.10
Operation
Not Assigned
You are doing in the Add/
Cancel operation, but
there is no jobs waiting.
Check the display to see if there
is any scheduled job. The display
should indicate them in Standby
mode, for example, Delay Fax.
[Paper Jam 0]
Open/Close Door
Paper has jammed in the
feeding area of the paper
tray.
Clear the jam. See page 8.4.
[Paper Jam 1]
Open/Close Door
• Paper has jammed in
the paper exit area.
• A paper jam has
occurred in the
manual feeder or the
machine detects non-
feeding from the
manual feeder.
Clear the jam. See page 8.6.
[Paper Jam 2]
Check Inside
Paper has jammed in the
fuser area.
Clear the jam. See page 8.5.
[Power Failure]
Power has turned off then
on and the machine’s
memory has not been
saved.
You need to start again the job
which you were trying to do
before the power failure.
[Retry Redial?]
The machine is waiting
for a specified time
interval to redial a
previously busy station.
You can press
Enter
to
immediately redial, or
Clear/
Stop
to cancel the redial
operation.
[Stop Pressed]
The
Clear/Stop
button
is pressed during a copy
or fax operation.
Try again.
[Toner Empty]
The toner cartridge has
run out. The machine
stops printing.
Replace with a new toner
cartridge. See page 7.9.
[Toner Low]
The toner cartridge is
almost empty.
Take out the toner cartridge and
gently shake it. By doing this,
you can temporarily reestablish
printing operations.
Display Meaning Suggested solutions