Ricoh 4016 Series All in One Printer User Manual


 
iii
CAUTION:
Power Supply
The socket-outlet shall be in stalled near the product and shall be easily accessible.
Ozone Safety
This product generates ozone during operation.
Normally, the ozone level is safe for operators. If ozone odor may appear, ventilate the room.
For Fax or Telephone
Do not use this product near water, for example, near a bathtub, wash bowl, kitchen sink or
laundry tub, in a wet basement or near a swimming pool. Avoid using a telephone during an
electrical storm. There may be a remote risk of electric shock from lightning. Do not use a
telephone in the vicinity of a gas leak to report the leak.
Laser Safety:
This equipment is considered a class 1 laser device. This equipment contains a 5 milliwatt, 760-800
nanometer wavelength, AlGaAs laser diode. The following marking is attached on the back of the
equipment.
Caution:
Use of controls or adjustment or performance of procedures other than those specified in
this Operating Instructions might result in hazardous radiation exposure.
For North America
Laser Safet
y:
This equipment complies with requirements of 21 CFR subchapter J for class 1 laser products.
This equipment contains a 5 milliwatt, 760–800 nanometer wavelength, AlGaAs laser diode.
Caution:
Use of controls or adjustment or performance of procedures other than those specified in this
Operating Instructions might result in hazardous radiation exposure.
Protect the machine from dampness or wet weather, such as rain and snow.
Unplug the power cord from the wall outlet before you move the machine. While moving
the machine, you should take care that the power cord will not be damaged under the
machine.
When you disconnect the power plug from the wall outlet, always pull the plug (not the
cable).
Do not allow paper clips, staples, or other small metallic objects to fall inside the
machine.
Keep toner (used or unused) and toner bottle out of the reach of children.
Be careful not to cut yourself on any sharp edges when you reach inside the product to
remove misfed sheets of paper or masters.
For environmental reasons, do not dispose of the machine or expended supply waste at
household waste collection points. Disposal can take place at an authorized dealer.
The inside of the machine could be very hot. Do not touch the parts with a label
indicating the “hot surface”. Otherwise, an injury might occur.