Filter
Top Products
4-31
Protection from Barge-In
Each station can be programmed as secure or not secure. Secure stations cannot be
barged-in on. A station that is not secure also cannot be barged-in on when talking to a
secure station.
Pullout Directory Tray
A pullout directory tray is located beneath some types of keyset (e.g. Euro). It is used to
record station directory names and speed dial numbers.
Pulse to Tone Switchover
When dialling a number on a dial pulse network, a station user can dial # and the system will
begin to send DTMF.
Redial
There are several types of external redial available to station users. Each type can redial up
to a maximum of 18 digits.
y AUTO RETRY—When an outside number is dialled and a busy signal is received, the auto retry
feature can be used to reserve the outside line and automatically redial the number for a
programmable number of attempts (available to keyset users only).
y LAST NUMBER—The most recently dialled number on a C.O. line is saved and may be redialled by
pressing the redial key or dialling the LNR access code.
y MANUAL RETRY with LNR—When you make an outside call and receive a busy signal you can
press the LNR key to redial the same number again. This operation can be manually repeated for a
limited number of attempts as defined by system programming (available to keyset users only).
y MEMO REDIAL—When you are calling directory assistance you can store the number you are
given using the dial pad and SAVE number feature (available to keyset users only).
y SAVED NUMBER—Any number dialled on a C.O. line may be saved for redial at a later time.
Remote Hold
You can place a call at a station on system hold at another station (on an available CALL key
or line key).
Ring Modes
Each keyset user can select one of three distinct ways to receive internal calls. The phone
can automatically answer on the speakerphone, voice announce through the speaker or
receive ringing. When the ring mode is selected, keyset users can choose one of eight
distinct ring tones. Forced Auto Answer is invoked by the calling station and is controlled by
the calling station’s class of service.
Ringing Preference
Lifting the handset or pressing the Speaker key automatically answers a call ringing at the
keyset. Using this method, users are assured of answering the oldest call first. When ringing
preference is turned off, the user must press the flashing key to answer. Users may answer
ringing lines in any order by pressing the flashing key.