Filter
Top Products
Section 3. Configuration
Page 3-16 PN 9001101 Rev. A SATO M10e
CARD MODE
The Card Mode allows the operator to manage the Expanded Memory (PCMCIA Card or
Internal Expanded Flash ROM).
CHARACTER PITCH
PROP FIXED
This selection allows you to set the default character pitch to
either fixed character spacing or proportional character spacing.
1. Use the Cursor keys to step the cursor to the desired
setting.
2. Once the correct setting is selected, pressing the ENTER
key will accept the setting and the display will return to the
Advanced Mode display.
ADVANCED MODE To exit the Advanced mode, power the printer off and then back
on.
V 05.00.03.00
INITIALIZING
Displays the firmware during the initialization.
ADVANCED MODE The Card Mode is entered from the Advanced Mode display by
pressing the Right Cursor key (>>)once.
CARD MODE The Card Mode display indicates that the printer is in the Card
Mode. To advance to the first selection, press the ENTER key.
MEM SELECT (CC1)
CARD MEMORY
This selection determines which type of optional expanded
memory will be addressed as “CC1" in the command
streams.The CARD selection specifies the optional PCMCIA
card as CC1 and the optional Expanded Flash ROM as CC2.
The Memory selection specifies the optional Expanded Flash
ROM as CC1 and the optional PCMCIA card as CC2.
1. Step the cursor to the desired selection using the Cursor
keys.
2. Once the cursor is positioned over the desired selection,
press the ENTER key to accept the selection and advance
the display.
CARD->MEMORYCOPY
TRUETYPEFONT Y/N
This selection allows you to copy TrueType fonts from the
PCMCIA Memory card installed in the Memory Card slot on the
rear of the printer to the optional Flash ROM.
1. Use the Cursor Keys to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode. If
No is selected, the display will advance to the Card to
Memory SATO Font Copy mode.
COPY START
YES NO
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
TRUETYPEFONTCOPY
COPYING
3. Press the ENTER key to accept the selection. If Yes was
selected the copy process will start.