A SERVICE OF

logo

Section 7: Replacement Procedures
SATO M10e Service Manual PN 9001113A Page 7-13
8 Secure replacement power supply (4) to printer base (3) using seven screws (5).
9 Connect all wiring harnesses and cables to power supply (4).
10 Place printer frame (2) onto printer base (3) and secure using seven screws (1).
11 Ensure the power switches are in the on position.
12 Restore power and test cycle to ensure proper function.
13 Replace the rear, right, left, and front housing covers.
Figure 7-10, Power Board Replacement
NOTE: Refer to Figure 10-5 of the Diagrams & Schematics section for
harness connection guidance.
NOTE: Figure 10-1 of the Diagrams & Schematics section provides guidance
on housing cover installation.
1
2
1
4
5
5
3