Filter
Top Products
Section 3. Configuration
SATO M10e PN 9001101 Rev. A Page 3-17
TRUETYPE
FONTCOPY
COMPLETED
4. Once the copy process is completed, press the ENTER key
to step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
CARD->MEMORYCOPY
SATOFONT Y/N
This selection allows you to copy SATO fonts from the PCMCIA
Memory card installed in the Memory Card slot on the rear of the
printer to the optional Flash ROM.
1. Use the Cursor keys to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode. If
No is selected, the display will advance to the Card to
Memory Copy All mode.
COPY START
YES NO
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
SATO FONT COPY
COPYING
3. Press the ENTER key to accept the selection. If Yes was
selected the copy process will start
SATO FONT COPY
COMPLETED
4. Once the copy process is completed, press the ENTER key
to step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
5. If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error Indicates a Read/Write error occured
No Card Error Indicates no card was recognized
Mem Full Error Indicates that there is insufficient memory
available.
MEMORY->CARDCOPY
ALL <0MB> Y/N
This selection allows you to copy the entire contents from the
PCMCIA Memory card installed in the Memory Card slot on the
rear of the printer to the optional internal Expanded Memory.
1. Use the Cursor keys to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode. If
No is selected, the display will advance to the Card to
Memory Copy All mode.
COPY START
YES NO
2. Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.